We're a little crazy, about science!

Posts tagged “Custom PC

Technology issues…

I’ve quickly come to regret purchasing my new(ish) fancy laptop. I get complements on it because it looks impressive and if it worked correctly it would be very impressive. The problem is that it has been causing me headaches since I bought it. Technically this is the second one, the first one was replaced and the second had the same exact issues. So instead of exchanging it again and going through that whole mess, I decided to crack it open and do the fixing myself.

(more…)

A beginners guide to watercooling, from a beginner.

I have built a lot of computers over the years. It’s actually not that hard to do since most things are labeled and use different types of connectors so it’s hard to screw it up unless you’re not paying attention. Up until recently I’ve never watercooled a PC, at least not in the build it myself sense. The internet is full of how-to guides to help you do this, but most of them are from people who do these types of builds regularly. I find that they skip over some of the basic things that you may need to know because they’ve forgotten that it’s not common knowledge. Since I’ve successfully finished my first build and don’t like hoarding knowledge, I want to share how to do it, for beginners, by a beginner.

(more…)

PC build part eight, closing the loop

It feels very sci-fi around here now!

As promised this is the grand finale to the custom water cooling hard tube build saga. As in, the computer is back up and running… finally. It’s been a journey, but I’m hopeful that the latest mods will keep me from having any more problems that I need to stop my work and fix. I mean modding your computer for fun is one thing, needing to do it is a whole other thing. Still, I’m thankful for the little pause and I got to make a few needed changes/upgrades while the computer was down so it isn’t all that terrible.

(more…)

PC build part seven, the tale of the leaky loop

It is done, well kind of!

Well I’ve done it… mostly. The loop is finally complete and I’ve pressure test it. There were of course some technical difficulties, which I resolved, but I also caused because I’m an idiot. I wasn’t planning on making another computer post until I had the thing turned on and finished, but today I want to tell the story of how a $20 USD part saved my computer.

(more…)

PC build part six, now with more bends!

So many bends, it’s an excessive number of bends.

Yep, still working on the hard tube bends. It’s a lot… harder than it looks! Pun fully intended. Today I have good news and bad news. The bad news is there’s still some work to be done before I get to pressure test and finally finish this build. The good news is there’s only one bend I need to make and one or two I would like to redo if I have enough tubing for it.

(more…)

PC build part five, the first bends

It’s not the tube that bends it is only yourself,… or some mystical crap like that.

We’re getting bendy! After all the work I had to do yesterday I didn’t think there would be time to bend tubing yesterday, but I was determined to get started and I did. The good news, some of it’s done. The bad news, bending tube isn’t easy. There was a lot of trial and error, even more waste, and even now it’s not perfect *sad face* … but it’s almost time to wrap this project up!

(more…)

PC build part four, electrical fire edition!

An explosion of wires!

Okay, okay clickbait headline, I admit it. If you’re here for a real electrical fire you’re out of luck. Thankfully I haven’t had an electrical fire… yet, I haven’t turned the computer on since I’ve started this project. However, a few things happened yesterday so I need to figure out my cable management before I get too much further. It’s something I’ve been ignoring and I’m finally sharing some of the mess that I’ve (somewhat purposefully) been hiding.

(more…)